In recent years, mobile phone signal jammers have become more and more common in people’s daily lives, but do you know how to install mobile phone signal jammers when they are assembled to stimulate their application effects? Cell Phone Blocker Signal Jammer Device The components generally include: server, wireless Antenna, adapter. When installing the mobile phone jammer, because there is a very strong electromagnetic field for data signals within a certain distance between the server and the wireless antenna (usually 20-30 cm), and at the same time, there is also near the 220V Power plug (weak current) (usually 5-10 cm). The electromagnetic field affects, therefore, how to arrange the assembly part of each component is very important, the placement part is wrong, cell phone jammer It is likely that the transmission of shielded data signals will be affected and the actual effect of shielding will be jeopardized.
The standard installation interval of each component of the mobile phone jammer is: the adapter should avoid 20cm above the server; (if the mobile phone jammer is assembled, subject to the installation conditions of the place, it is not guaranteed to avoid the switching Power supply, and the adapter can be placed Under the mobile phone jammer server, after choosing this method, the adapter will still get some influence from the Cell Phone Blocker Signal Jammer Device server magnetic field, which is less affected than if the adapter is close to the server.) Near the wireless antenna There is no weak circuit line (AC220V) within the 20cm range; (including the upper and lower sides of the wireless antenna, the upper side of the wireless antenna, the weak current bright line embedded in the wall body of the wireless antenna, etc., if it can not be placed, please try not to be within 10cm of the wireless antenna) When the distance between the communication base station is less than 200 meters, the actual shielding effect is inversely proportional to the distance from the communication base station. That is, the closer the communication base station, the smaller the shielding radius. Tighten the wireless antenna before plugging in. The wireless antenna must be vertical (⊥). The data marked on the wireless antenna must correspond to the data marked by the wireless antenna hole on the server. There is no need to plug in the wrong way, let alone connect the wireless antenna. At the same time, Power on the chassis.
